Pride Audio Uno XL 2 Monoblock Amplifier
Many in-stock orders ship within 1-2 business days, but timing varies by item. Custom, built-to-order, oversized, special-order, and supplier-direct products may need extra processing time. Free shipping applies to qualifying orders over $99 within the contiguous US. Freight items may require delivery coordination; any shipping exceptions are shown before checkout. Approved returns may be subject to a restocking fee.
Most products are covered by the manufacturer's warranty against defects. Damage from over-powering or improper installation isn't covered — we'll help coordinate any valid claim.
Tell us your vehicle, subwoofers and electrical setup and our team will help you match the right gear. Reach out before you buy.
Subwoofer Wiring Diagram
Select your configuration to view possible wiring combinations.
Loading wiring diagrams…
Diagrams are on our wiring diagram page.
The Pride Audio Uno XL 2 is a single-channel monoblock built for one job: driving subwoofers hard in a dedicated bass system. It delivers up to 1200 watts RMS into a 1-ohm load, also check out the Pride Uno v2 Amplifier with a low-frequency-focused signal path, making it a fit for SPL and daily-loud builds running one or a pair of low-impedance subs. A remote bass knob with a "Klipp" clipping indicator keeps tuning within reach from the driver's seat.
Key Features
- 1-channel (monoblock) design dedicated to subwoofer duty
- Up to 1200W RMS at 1 ohm; stable down to a 1-ohm load
- Bass-focused 15Hz–270Hz frequency response
- Adjustable bass boost from 0 to 9 dB
- Variable low-pass filter (35Hz–250Hz) and subsonic filter (10Hz–50Hz)
- High efficiency (over 90% at 4 ohm) with a damping factor greater than 200
- Included remote level control with LED "Klipp" distortion/overload indicator
- 120A fusing on board (4 × 30A)
- Not designed for bridged operation
Specifications
| Specification | Value |
|---|---|
| Channels | 1 (monoblock) |
| RMS Power @ 1 ohm | 1200W |
| RMS Power @ 2 ohm | 900W |
| RMS Power @ 4 ohm | 500W |
| Frequency Response | 15Hz – 270Hz |
| THD | 5% |
| Signal-to-Noise Ratio | 85 dB |
| Input Sensitivity | 8V – 0.3V |
| Damping Factor | >200 |
| Efficiency @ 4 ohm | Over 90% |
| Bass Boost | 0 – 9 dB |
| Low-Pass Filter | 35Hz – 250Hz |
| Subsonic Filter | 10Hz – 50Hz |
| Fuse Rating | 120A (4 × 30A) |
| Dimensions (L × W × H) | 300 × 220 × 53 mm |
To pull full output, wire your subwoofer load to 1 ohm and feed the amplifier with adequate gauge power and ground plus solid charging support, since 1200W RMS draws serious current. Because the Uno XL 2 is not made for bridging, plan your subwoofer voice-coil configuration around a single-channel, low-impedance final load.
